As I said..nothing really came up during the installation!
I removed the dhcp from the etc/networks and changed it to ones i found on thei nternet and its still not working..in fact i messed up the network config =¸¸=
tried putting several ip adresses in browser x.x.x.x/admin and none really loaded
when i enter my ip adress..i guess its the ip of my wifi router a page shows up saying Username or Password is incorrect.
Please refer to the troubleshooting below:"
Last edited by ToXiPhobia; 21-08-14 at 02:52 AM.
Hey tox , did you run your linux server on vmware or virtualbox or something else ?
Apparently my virtualbox wont start up anymore .
Originally Posted by nationss
Virtual box..its working for meh
bro i keep getting an error when i try makin a new one . it goes through the process but when i try and start it , it fails o.O
which error?
you got kik bro ? I rather send you the pictures
I dont..and I dont think i will be much of a help :/ i just followed the video guide in 343s old release
Ahhh , well idk why i cant start the ubuntu server . but goodluck man ,
Help 343 please D: I need you! I seriously dont know how should I change dhcp to auto config..i tried as i mentioned in my last post but the webpage still does not load!
open /etc/network/interfaces
Depending on how your network (router) is setup, change the info in red to suit
change the adapter in blue to suit
# The loopback network interface
auto lo
iface lo inet loopback
# The primary network interface
auto eth0
iface eth0 inet static
address 192.168.1.10 <--ip you want ubuntu to have
netmask 255.255.255.0
gateway 192.168.1.1 <--usually router address
save the file and run
Code:sudo /etc/init.d/networking restart
Still confused on why anyone is trying to use the old release, not that it was hard to install/run either but still don't get it.
When i unpacked PW_Dev then i got virus, my internet shutsdown, i lagg and my audio has been fucked up from it. Any clues about this 343?
# The loopback network interface
auto lo
iface lo inet loopback
# The primary network interface
auto /my ipv4 adress/? or just Ipv4 or leave eth0?
iface /my ipv4 adress/ inet static? or just leave ipv4 or leave eth0?
address 192.168.51.1 <--ip you want ubuntu to have
netmask 255.255.255.0
gateway 192.168.0.1 <--usually router address
Like this?? It gave me an error =¸¸=
"missing required variable adress..missing required configuration variables for interface eth0/inet
edit: tried "sudo invoke-rc.d networking stop ; sudo invoke-rc.d networking start" and it restarted i guess
anyway the webpage still wont load!
Last edited by ToXiPhobia; 21-08-14 at 02:43 PM.
no like this obviously change adapter, ip and masks to suit
dont be confused with the "auto eth0" bit that just automatically enables that adapterCode:# The loopback network interface auto lo iface lo inet loopback # The primary network interface auto eth0 iface eth0 inet static address 192.168.1.10 netmask 255.255.255.0 gateway 192.168.1.1
I have set it to those of yours and even changed it in both server.txts and the page doesnt not load nor the server :/
Do i put the number in "address" to browser and to server.txt files?
Reply With Quote