who can help me pls
Printable View
who can help me pls
@Psytrac
can you upload for me your server files?
- - - Updated - - -
this my problem ..Quote:
TRACE : TRACE : KeepAlive sid=8
gdelivery::connect to gauthd successfully.
err : Protocol Unknown . sid=143,type=1,size=50,acceptsize=41
debug : Protocol Unknown . sid=71,type=527,size=29,acceptsize=6
err : gdelivery::disconnect from GAuth server. Reconnecting....
TRACE : gdelivery::connect to gauthd successfully.
err : Protocol Unknown . sid=145,type=1,size=50,acceptsize=41
debug : Protocol Unknown . sid=72,type=527,size=29,acceptsize=6
err : gdelivery::disconnect from GAuth server. Reconnecting....
TRACE : gdelivery::connect to gauthd successfully.
err : Protocol Unknown . sid=147,type=1,size=50,acceptsize=41
debug : Protocol Unknown . sid=73,type=527,size=29,acceptsize=6
err : gdelivery::disconnect from GAuth server. Reconnecting....
who can help me
i can pay to you $_$ @Psytrac @whoami1995 @HyperSin
Check your isec/osec/shared key between your Auth and the gedeliveryd configuration filesQuote:
Originally Posted by louka2
gdeliveryd
https://forum.ragezone.com/cache.php...m%2FhvtfeN.png
auth
https://forum.ragezone.com/cache.php...m%2FEztAGR.png
@whoami1995
not the same ! this is the problem ?
shouldent matter there are times my server does the same thing, it means the start up is alittle bit behind, just sit and wait for it to catch up, if it does catch up and it still does that then something inthe configuration files is not right
that setup is all kinds of fucked up.
first off authd should have those without ";" and make sure that isec and osec keys match up, that is one of the main issues with connections
ok i will try
solved but when i try to open shop a message show up "that service is not aviable here"
how i can solve it ?
assuming your trying to open gshop, LEAVE place of origination. you cannot open it there.
yeah thanks ..
another problem :3
i can't change the experience rate
First try the ptemplate.conf file then if that does not work you need to edit the gs manually...
base_offset
offset1
offset2
offset3
offset4
offset5
offset6
where i should make the change?
Offsets?
Spoiler: