hi everyone... im using somekind of season2 files.. i config the ip's this way everywhere i put 192.168.100.100 except in connectserver and in data/iplist/mapserverinfo.dat and in data/lang/kor/commonlog. Everytime i try to move in crywolf from M move menu it stucks for a second and then unstuck and im in the same town and then it disconnect me. After 2-3 tries its shows "account already connected". Any ideas ?
Last edited by EnErDjIIIII; 14-07-11 at 07:15 PM.
k mainly , please wait atleast 1-2 days after bumping ur thread :)
1.
why u havent editoed iplist with ur lan ip and also mapserverinfo.dat with ur lan ip and commonlog with ur lan ip? what will happen if u do?.
thats a litle buggy thing about account already connected it can be fixed also if u read those 3 tuts
1. http://forum.ragezone.com/f196/resol...roblem-167123/
2.http://forum.ragezone.com/f196/fix-a...-issue-228382/
3.
http://forum.ragezone.com/f196/accou...-1-02n-330580/
good luck.
i already did this fix i just had to point this problem it may have been useful in reminding you for the same probelm. Also tried with all lan ips not working. Will try again ... tnx for your "normal" answer.Originally Posted by karLi
crywoulf problems always comes from GS_CS did you tried to run it ?
of course i run it .. no errors
is the 55919 port opened right?
not sure will check... normally this port shouldn't be opened ... i didnt have any problem moving in crywolf on s4/5/6.
but crywolf is CS Server and its 55919 why is not needed?.
dont know from 4 years every server i runned i never opened 55919 and it worked :D but this time will try with opening this port.
edit: if gs_cs was in "show" mode in connectserver than this port must be opened cause the server will be used as a normal gs. But in "hide" mode it runs under the normal gs.
Last edited by EnErDjIIIII; 16-07-11 at 06:44 PM.
just open and we'll see.
