Setting up IPs for 99.6XT for ROUTER

I made this cause no one F*CKING posted a guide for this. I'm sorry for the swearing it's just that I'm pissed off that it took me SO long to set up the server, when someone could've just told me how to set up the server when I had asked. Follow the steps below:

1) Open CS folder of MuServer folder.
2) Go to www.whatismyip.org and copy the IP address. This is your WAN IP.
3) Go to Start > Run and type in "cmd" and click OK. Type in "ipconfig" and press ENTER you will get a IP address listed, remember it because this is your local ip.
4) WAN IP into Connectserverlist.dat, ServerInfo.dat, Serverlist.dat, and Connectserverlist.dat.
5) Open RankingServer folder, and open "svconfig.ini" type in password in password area.
6) Open ExDB folder, and open "exdb.ini" type in password in password area.
7) Open EventServer folder, open DATA folder, then open "svconfig.ini" type in password.
8) Open DATA folder. Open "IpList.dat" and change to WAN IP.
9) Open "MapServerInfo.dat" and change all IPs to WAN IP.
10) Open "commonserver.cfg" and change all IPs to local IP.
11) Go to "LANG" folder and change IP to local IP.
12) Now go to the "LINKS" folder and open MuServerStartUp, then click configuration.
13) Now all the IPs you see in here you have to change to LAN IP.
14) If you see a word like :ip: then replace that with LAN IP.
15) Save the configuration and exit the configuration.
16) Type in WAN IP for MuServerStartUp and click START.

HAVE FUN!

How about on how to restore the DB? coz it has extra db and u know wat i mean sir!

Thiss like a Fuck NO-IP, you testing others configurations?

LoL barely found your guide after hours of searching for correct way to setup ips.

Translated in Spanish / Traducido al espa

put password in the password area?????
what password should i put in password area?

put password in the password area?
what password should i put in the password area?

when i raise or up the server with the ip wan, we can

when i raise or up the server with the ip wan, we can

How can I do this without using MuServerStartUp?????

How can I do this without using MuStartUp program, just with Links folder?????

In the Startup.ini file the :ip: is a placeholder for the IP you enter when you launch the server. So if you replace your :ip: 's in the ini-file to you local IP,
there will be no diference in what you are typing in. Anyway, if you put your local IPs instead of the IP you do nothing wrong. Important are global IPs in the CS folder. Some servrs connect only with global IP in \data\lang\chs\...

nice dude nice :PP im gona use this :P

what ports do I have to open in my router?