Starting up the server, error! Using Antrix 2.1.0

Hello folks, I just downloaded everything that's needed for an Antrix 2.1.0 server.
I did the guide but I got a problem when I am trying to start my server.

I get this message:
http://img501.imageshack.us/img501/2351/errorng3.jpg

I have tried to change the "127.0.0.1" ip to my own, but it doesn't work.
I have also tried to shut down my firewall, but still doesn't work.
Whats wrong? Can it be fixed?


Please help a beginner, I'm begging you.

Have u started logonserver.exe?

Quote:

---

Originally Posted by eple

Have u started logonserver.exe?

---

yes, but is it suppost to shut down?
when I start it, it closes down 1-2 sec afterwards.

post logonserver configs

Quote:

---

Originally Posted by eple

post logonserver configs

---

#######################################################################
# Configuration File (Logon)
# Last updated at revision 1259
#######################################################################

# LogonDatabase Section
#
# These directives are the location of the `realms` and `accounts`
# tables.
#
# LogonDatabase.Host - The hostname that the database is located on
# LogonDatabase.Username - The username used for the mysql connection
# LogonDatabase.Password - The password used for the mysql connection
# LogonDatabase.Name - The database name
# LogonDatabase.Port - Port that MySQL listens on. Usually 3306.
# LogonDatabase.Type - Client to use. 1 = MySQL, 2 = PostgreSQL, 3 = Oracle 10g
#

LogonDatabase.Hostname = 127.0.0.1
LogonDatabase.Username = root
LogonDatabase.Password =
LogonDatabase.Name = antrix
LogonDatabase.Port = 3306
LogonDatabase.Type = 1

# Host Directive
#
# This is the address that the realmlist will listen on.
# To listen on all addresses, set it to 0.0.0.0
# Default: 127.0.0.1 (localhost)
#

Host = 0.0.0.0


# Realm List Listen Port Directive
#
# This is the port that the realm list listens on.
# Unless you have modded the clients, this will
# always be 3724.
#
# Default: 3724
#

RealmListPort = 3724


# Server console logging level
#
# This directive controls how much output the server will
# display in it's console. Set to 0 for none.
# 0 = Minimum; 1 = Error; 2 = Detail; 3 = Full/Debug
# Default: 3
#

LogLevel = 0

# Account Refresh Time
#
# This controls on which time interval accounts gets
# refreshed. (In seconds)
# Default = 600
#

AccountRefresh = 600

# Accepted Build Range Setup
#
# These two directives set up which clients will be
# allowed to authenticate with the realm list.
#
# Set these to the same builds that the server was
# compiled for.
#
# As of the last update, version 2.1.0 was build 6692.
#

MinClientBuild = 6692
MaxClientBuild = 6692


# Socket Threads Delay
#
# This directive controls the delay between loops of the socket worker threads.
# Usually 20ms works nicely, although if you have a much larger server higher
# values might work better.
# Default: 20 (20ms)
#

Network.ThreadDelay = 20


# Socket Thread Count
#
# This directive controls the amount of socket worker threads that will be spawned
# by the server. New sockets are then dynamically balanced out on these threads.
# Again, if you have a much larger server a higher value may improve latency.
# Default: 5
#

Network.ThreadCount = 5

Do you make to take a screen why it close?