Mikrotik Router for your RYL server

Hardware needed
1. PC with minimum spec
- Processor intel pentium III 700Mhz
- Memory 512Mb
- HDD 10Gb
- 2 LAN Card
2. Switch Hub minimum 4 Port

PC can replace with Routerboard RB 750 RB750

======================================================================

Hardware flowchart
For PC and Routerboard

MODEM --> LAN CARD 1 at PC
LAN CARD 2 at PC --> Switch Hub
Switch Hub --> Your Server
Switch Hub --> Your PC

Picture can see at attachment
=====================================================================

Installation for PC
1. Download Cracked Mikrotik Here Cracked Mikrotik

2. After download here next step Install from CD

3. After finish install login to your router
Username : admin
Password : (just leave it blank)

Interface will be like this

[admin@Mikrotik] >

Now setting up IP Address
1. Setting your IP from modem
[admin@Mikrotik] > /ip address add address=your ip address interface=ether1
example : /ip address add address=202.43.180.151/32 interface=ether1
2. Setting your Local IP
[admin@Mikrotik] > /ip address add address=your ip address interface=ether2
example : /ip address add address=192.168.100.1/24 interface=ether2
3. Setting gateway of your internet (see modem config)
[admin@Mikrotik] > /ip route add gateway=your internet gateway
example : ip route add gateway=202.43.180.149
4. Setting DNS (See modem config)
[admin@Mikrotik] > /ip dns set primary-dns=your dns from modem allow-remoterequests=no
[admin@Mikrotik] > /ip dns set secondary-dns=your dns from modem allow-remoterequests=no
Example : /ip dns set primary-dns=202.43.178.244 allow-remoterequests=no
/ip dns set secondary-dns=202.43.178.245 allow-remoterequests=no
5. Checking connection to internet
[admin@Mikrotik] > ping Yahoo!
216.109.112.135 64 byte ping: ttl=48 time=250 ms
216.109.112.135 64 byte ping: ttl=48 time=250 ms

that result if work press ctrl + c to stop ping
if dont work there will be request time out result.
6. Setting masquerade fow allowing your client computer access internet
[admin@Mikrotik] > /ip firewall nat add action=masquerade out-interface=ether1 chain=srcnat

===========================================================================================

im sorry, due to unexpected event i will post next step later...
1. installing for routerboard
2. port forwarding
3. block ip address
4. block port scanning and ddos

700 MHZ that slow pc dont you think?

Quote:

---

Originally Posted by oldcid

700 MHZ that slow pc dont you think?

---

not really, routerboard processor event slower and less memory and disk space.
since it's function just for routing, block ip's, and other small function not necesary have good spec.